Sekonic L-508 CINE ZOOM MASTER Manual de Instruções descarregar pdf (Página 8)

5. Measurement

3. Press the Measuring button 19 to make a

measurement.

Release the Measuring button to complete the

measurement. The measured value (shutter

speed) at the time will be displayed.

While pressing the Measuring button, the meter

measures continuously until it is released.

Reference:

•You can set f stops from F1.0 to F128 (full f stops)

•Even after taking the measurement, you can change the f stop value by turning the Set/

change dial, to display a new measured value (shutter speed).

1-3 EV mode

Open the Battery compartment cover 20 and slide the EV DIP switch (see page 8) to the ON

position.

1. Hold down the Mode set button 10 and turn the

Set/change dial 5 to select EV value mode.

2. Press the Measuring button to make a

measurement. Release the Measuring button to

complete the measurement. The measured value

(EV value) at that time will be displayed.

At the same time, the shutter speed will be

displayed in the digital display area, and the

corresponding f stop will be displayed in the

analog display area.

While pressing the measuring button, the meter

measures continuously until it is released.

Reference:

•"E.u" (Exposure under) or "E.o" (Exposure over) appears when the combination of shutter

speed and aperture is not possible for the measured light level. Changing the shutter

speed and or aperture with the Set/change dial will allow you to find a combination that

is possible.

If the "E.u" or "E.o" readout blinks, this indicates that the light level is beyond the

measurement range of the light meter.

-11-

5. Measurement

1-4 Cinematography

1. Hold down the Mode set button 10 and turn the

Set/change dial 5 to select ambient light shutter

speed priority mode.

2. Turn the Set/change dial to select the Cine Speed

for the camera that will be used. Cine Speed is

displayed after 1/8000, 1/200, 1/400 and the unit

are in frames per second (FPS). The following

Cine Speeds will display:

2, 3, 4, 6, 8, 12, 16, 18, 24, 25, 30, 32, 36, 40, 48,

60, 64, 72, 96, 120, 128, 150, 200, 240, 256, 300

and 360 FPS.

• The shutter opening angle that these speeds

are based on, is 180 degrees. For other angles

make the following ISO film speed corrections.

* Example of correction value

-1/3: Decrease ISO film speed by 1/3 stop, example: ISO 100 -1/3 stop = ISO 80

+1/3: Increase ISO film speed by 1/3 stop, example: ISO 100 +1/3 stop = ISO 125

4. Press the Measuring button 19 to make a

measurement. Release the Measuring button to

complete the measurement. The measured value

(f stop value) will be displayed.

While pressing the measuring button, the meter

measures continuously until it is released.

-12-

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Sekonic L-508 CINE ZOOM MASTER Manual de Instruções Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Medição, teste e controlo Sekonic L-508 CINE ZOOM MASTER