Sekonic MULTIMASTER L-408 Instruções de Operação descarregar pdf (Página 21)

8. Flash Measurement without cord

8.1 Single flash metering

<jr!

Flash measurement without cord

(Flash measurement without cord) mode using the mode selection

button.

Single flash measurement

Select the single flash measurement mode using the F/EV/MULTI button.

Shutter speed setup

Set the desired shutter speed using the UP/DOWN button.

NOTE

+ In this mode, you can set the shutter speed from 1 sec to 1/500 sec.

After 1/500 sec., 1/75, 1/80, 1/90, 1/100, 1/200 and 1/400 sec. appear in

the display and you can select a particular shutter speed.

Cj>

Measurement

Press the measuring switch. The mark will

appear and your L-408 is ready to measure

(Standby mode)

When the flash fires, your L-408 displays the

correct exposure.

NOTES

After this measurement, the

remains in standby mode.

mark continues to blink and your L-408

0 The standby mode continues for approximately 90 seconds and you can

measure again within this time. If the mark goes out after 90 seconds

press the measuring switch again.

When you change the film speed, the measurement is recalculated and

a new correct value is displayed.

l If the flash is NOT metered by your L-408 (when the flash is dimmer

than the ambient light), use flash measurement with cord.

If the shutter speed is changed after measurement, the measurement is

lost and the aperture is cleared to zero (0).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27

Sem comentários

Sekonic MULTIMASTER L-408 Instruções de Operação Página 21