Sekonic SR-430 Especificações descarregar pdf (Página 22)

-13-

5. Operation

5-A Preparation

Install the device and open the stacker. Set the card stopper at an appropriate position for the card

size to be used and raise the side guard at the specified position. (Make sure that the card stopper has

not been set inside out.)

During this operation, be careful not to allow bright light to directly enter the card ejector or hopper.

Open the stacker.

Raise the side guard.

Card stopper and card size

Position A: Long-sized card

Position B: Standard-sized card

Position C: Postcard-sized card

Stopper plate

When using long-sized cards it is recommended to use the stopper plate so as to prevent paper from

coming out of the stacker.

Setting method: Engage the angled hole on the stopper plate with the protrusion at the center of the

top cover and firmly set it so that it is not disengaged even after you take off the hands.

(Be careful that the front and rear surfaces are set properly.)

5.Operation

Set the card stopper

like this.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Sem comentários

Sekonic SR-430 Especificações Página 22