Sekonic SR-430 Especificações descarregar pdf (Página 38)

-29-

-4 DLE T Command (Timing Format Setting Command)

[Explanation]

This command is for setting mark read timing (timing mark type). If the DIP switch setting has not

been changed, the setting by this command is not required when the power is turned on.

When the T command is executed, the set value remains unchanged unless the device is reset or the

power is turned off.

When using the timing control type, be sure to set the read timing by this command.

-4-1 In SR-430 (SR-410 compatible) mode

[Format]

Host Computer This device

DLE T CR STX N CR Receive

(10H) (55H) (0DH) (02H) (0DH)

* N: Specifies the format (1-byte ASCII numerical code between 1 and 5)

N values determine the mark read areas in the formats shown in the table below:

Setting method of timing control type

Specifying the timing control type with N = 1 when specifying the T command sets the read area at

three times of the timing mark.

[Format]

DLE T CR STX 1 CR

(10H) (55H) (0DH) (02H) (31H) (0DH)

NtamrofgnimitdaerkraM

1epytlortnocgnimiT

2epytrednu-tceriD

3desutoN

epytkram-ot-kraM

)daerebottonecapsknalbrodne(

epytkram-ot-kraM

)daerebotecapsknalbrodne(

9.Control Commands

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 75 76

Sem comentários

Sekonic SR-430 Especificações Página 38