Sekonic SR-430 Especificações descarregar pdf (Página 37)

-28-

-3 DC3 DD Command (Reading Density Difference Setting Command)

[Explanation]

This command is for setting the density difference allowable from the darkest mark in the CA and EA

modes.

After setting the difference, marks thinner than the setting are cancelled and those in the allowable

range are all output.

The density difference is set at "01" by default. In this case, mark data of the darkest density are

output.

This setting is not stored after the power is turned off.

* This applies to when the CAN command is executed.

Notes 1. Relationship with the sensitivity level setting

When there is one mark, the existence is judged according to the set sensitivity

level.

When there are more than one mark, the density differences are compared among

those at the set level or more and marks under the set level are cancelled.

2. When there are more than one mark at the same density level, more than one

pieces of data are also output.

e.g.1. When the density level is set at 2 and there are marks of density 6, 4 and 3

If the density difference of 3 is specified, the mark under the density level of 3 (6 - 3

= 3) is cancelled and two pieces of data of density 6 and 4 are judged to exist and

output.

e.g.2. When the density level is set at 4 and there are marks of density 8, 5, 4 and 3

If the density difference of 3 is specified, the mark under the density level of 4,

namely, the mark of density 3, is first cancelled due to the sensitivity level setting

and then the marks under the density level of 5 (8 - 3 = 5) are cancelled. Thus, data

of density 8 is judged to exist and output.

[Format]

DC3 D D N1 N2 CR

(13H) (44H) (44H) (0DH)

N1N2: 2-byte ASCII code

9.Control Commands

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 75 76

Sem comentários

Sekonic SR-430 Especificações Página 37